Have media loaded, a heavier roll is recommended. A 12 inch scale with Millimeter is required, however, an 18 inch or larger is ideal. It also is ideal to have heaters set to normal temperatures for this media to properly complete this procedure.
STEP 1
Press the MENU KEY (SETUP)
Press the RIGHT ARROW KEY ONCE TO ENTER SETUP MENU. SET 1: USER
TYPE, Press ENTER
IT WILL SAY TYPE 1
Press ENTER (PRINT MODE) ARROW DOWN TWICE TO PF ADJUST. RIGHT ARROW ONCE to INITIAL PRINT,
Press ENTER FEED LENGTH (DEFAULT = 250) (USE 400 OR 450 IF SCALE of ruler ALLOWS) use up/down arrows to adjust
Press ENTER (INITIAL ADJUSTMENT PRINT WILL NOW PRINT 2 HASH BLACK MARKS DOWN EDGES OF MEDIA, MEASURE THE PRINT AS ACCURATELY AS POSSIBLE AND REMEMBER THE NUMBER (EXAMPLE 249.5)
STEP 2
Press the MENU KEY (SETUP)
Press the RIGHT ARROW KEY ONCE TO ENTER SETUP MENU.
SET 1: USER TYPE, Press ENTER
IT WILL SAY TYPE 1
Press ENTER (PRINT MODE) ARROW DOWN TWICE TO PF ADJUSTS.
RIGHT ARROW ONCE to INITIAL PRINT
Press DOWN ARROW ONCE (INITIAL CHANGE) Press ENTER
ENTER IN THE MEASURED VALUE FROM STEP 1 (USING UP/DOWN ARROWS, THEN
Press ENTER)
DOWN ARROW ONCE (CONFIRM PRINT) AND Press ENTER TWICE.
(THE CONFIRM PRINT, 2 HASH MARKS IN MAGENTA WILL NOW PRINT DOWN EDGES OF MEDIA VERY LIGHTLY) AS ACCURATELY AS POSSIBLE MEASURE, IT SHOULD BE EXACTLY OR VERY CLOSE TO FEED LENGTH THAT WAS ENTERED IN STEP ONE. IF NOT, PERFORM PROCEDURE OVER.
Note: This adjustment is only as accurate as the measurements you make…